DIN 2353 hydraulic compression fittings with cutting ring size chart

The newest 2013 Edition DIN 2353 Standard PDF is published on January 2013, it is Non-soldering compression fittings with cutting ring Complete fittings and survey.

The complete non-soldered pipe fittings with a compression ring (ferrule) and union nut according to DIN EN ISO 8434-1, that are provided with a short tapered stud end or male stud end according to DIN 3852-1 and DIN 3852-2.

This standard gives an overview of the types and dimensions of compression fittings and couplings that are assembled from standardized parts and are not covered in DIN EN ISO 8434-1. It can be used to select fittings and determine the size of assemblies.

NOTE Standard design straight stud ends are covered in DIN EN ISO 8434-1.

DIN 2353 Stud fittings with type C (taper) stud end as in DIN 3852-1 and DIN 3852-2

It is recommended not to adopt the L and S series of fittings with tapered stud end for new designs. In these cases, types C and D fittings should be used instead of types A and B,and types DD,EE and FF swivel adapters together with DIN 3901 straight (male stud) fittings instead of types F, G, M, N, AA, and AB.

Designation of a straight fitting with metric thread (A),extra light duty series (LL),in steel(St),for an 8 mm pipe outside diameter (8):     Fitting DIN 2353-ALL8-St

din 2353 dimensions Taper thread type of figures

Stud fittings with type A or B (Male) stud end as in DIN 3852-1 and DIN 3852-2

Designation of a straight fitting with pipe thread (D), heavy duty series (S),in steel(St),for an 12 mm pipe outside diameter (12): Fitting DIN 2353-DS12A-St (Designation of din 2353 24 cone end is easy to read)

If stud be supplied with a thread of size G 1/2”, the designation should be amended to read: Fitting DIN 2353-DS12A-G1/2-St

din hydraulic fittings chart of male stud end type A and B

Union fittings, bulkhead fittings, swivel adaptors, weld-on or weld-in fittings according to DIN EN ISO 8434-1 standards.